- How wide should a gate be?
- Is 2 feet deep enough for fence posts?
- Do line posts need concrete?
- How far apart should chain link gate posts be?
- How much smaller should a gate be than the opening?
- Which side do hinges go on a gate?
- How do I determine my gate size?
- What size hinges do I need for my gate?
- Should a gate open in or out?
- Where should hinges be placed on a gate?
How wide should a gate be?
Next consider the width of the gate.
A single gate should not be built much wider than 42 inches, or 3.5 feet.
A wider gate will lower the angle of the cross-brace and the gate will sag as described above.
To ensure a cross-brace angle of greater than 45 degrees, the door height must be greater than the width..
Is 2 feet deep enough for fence posts?
The minimum depth that you should dig your fence post holes for panel sections is 2 feet. A general formula is to dig the holes one-third to one-half of the post’s aboveground height. The deeper you dig the holes, the more stability your fence has, but you must also purchase longer posts.
Do line posts need concrete?
Know Your Soil Composition The type of soil you’ll be setting fence posts in will help determine how stable the ground is, and how much you can expect the posts to move over time. … Clay soil also expands and contracts quite a bit with moisture fluctuations, so concrete anchors are a must.
How far apart should chain link gate posts be?
As chain link fence posts are smaller and sturdier than many other types, the holes should be smaller and can be farther apart. Follow the fence manufacturer’s instructions for spacing, which typically ranges from 4-10′ apart—spacing should not exceed 10′ on-center. (fig.
How much smaller should a gate be than the opening?
Measure the gate opening with a tape measure and construct the gate so that it is 1/2-inch narrower than the opening. If the gate is already constructed, measure the width and trim it with a circular saw, if necessary.
Which side do hinges go on a gate?
The hinges for gates are always fitted on either the front or rear face of the post or wall plate and never between the post and the gate. Handing is the side of the hand on the gate.
How do I determine my gate size?
Gate sizing is based on the type of material being molded and the wall thickness of the part. Since all good part designs use uniform wall thickness, I size the gate depth based on the nominal wall. If the part design includes some thicker sections, then I base the gate depth on the thickest wall section.
What size hinges do I need for my gate?
AS A GENERAL RULE OF THUMB THE HINGES YOU CHOOSE SHOULD REACH APPROXIMATELY HALF WAY ACROSS YOUR GATES. So if your gates are 5′ wide you should buy 30″ inch hinges.
Should a gate open in or out?
Swing Inward or Outward? Your gate should always swing inward. Why? You want the gate to move towards private space, not out to the public.
Where should hinges be placed on a gate?
Position the bottom hinge against the gate to locate the best location. Place the hinges where the gate will ultimately swing in the direction you desire, either away from the enclosure or into the enclosure. Some hinge types are able to swing in both directions.